In cases where Emacs does not automatically choose the right coding system for a file's contents, you can use these commands to specify one:
The command C-x <RET> f
set-buffer-file-coding-system) sets the file coding system for
the current buffer—in other words, it says which coding system to
use when saving or reverting the visited file. You specify which
coding system using the minibuffer. If you specify a coding system
that cannot handle all of the characters in the buffer, Emacs warns
you about the troublesome characters when you actually save the
You can also use this command to specify the end-of-line conversion (see end-of-line conversion) for encoding the current buffer. For example, C-x <RET> f dos <RET> will cause Emacs to save the current buffer's text with DOS-style CRLF line endings.
Another way to specify the coding system for a file is when you visit
the file. First use the command C-x <RET> c
universal-coding-system-argument); this command uses the
minibuffer to read a coding system name. After you exit the minibuffer,
the specified coding system is used for the immediately following
So if the immediately following command is C-x C-f, for example, it reads the file using that coding system (and records the coding system for when you later save the file). Or if the immediately following command is C-x C-w, it writes the file using that coding system. When you specify the coding system for saving in this way, instead of with C-x <RET> f, there is no warning if the buffer contains characters that the coding system cannot handle.
Other file commands affected by a specified coding system include C-x i and C-x C-v, as well as the other-window variants of C-x C-f. C-x <RET> c also affects commands that start subprocesses, including M-x shell (see Shell). If the immediately following command does not use the coding system, then C-x <RET> c ultimately has no effect.
An easy way to visit a file with no conversion is with the M-x find-file-literally command. See Visiting.
The default value of the variable
specifies the choice of coding system to use when you create a new file.
It applies when you find a new file, and when you create a buffer and
then save it in a file. Selecting a language environment typically sets
this variable to a good choice of default coding system for that language
If you visit a file with a wrong coding system, you can correct this
with C-x <RET> r (
This visits the current file again, using a coding system you specify.
If a piece of text has already been inserted into a buffer using the wrong coding system, you can redo the decoding of it using M-x recode-region. This prompts you for the proper coding system, then for the wrong coding system that was actually used, and does the conversion. It first encodes the region using the wrong coding system, then decodes it again using the proper coding system.blog comments powered by Disqus