Emacs keeps a flag called the modified flag for each buffer, to
record whether you have changed the text of the buffer. This flag is
set to t whenever you alter the contents of the buffer, and
nil when you save it. Thus, the flag shows whether
there are unsaved changes. The flag value is normally shown in the mode
line (see Mode Line Variables), and controls saving (see Saving Buffers) and auto-saving (see Auto-Saving).
Some Lisp programs set the flag explicitly. For example, the function
set-visited-file-name sets the flag to t, because the text
does not match the newly-visited file, even if it is unchanged from the
file formerly visited.
The functions that modify the contents of buffers are described in Text.
This function returns t if the buffer buffer has been modified
since it was last read in from a file or saved, or
otherwise. If buffer is not supplied, the current buffer
This function marks the current buffer as modified if flag is
nil, or as unmodified if the flag is
Another effect of calling this function is to cause unconditional
redisplay of the mode line for the current buffer. In fact, the
force-mode-line-update works by doing this:
set-buffer-modified-p, but does not force redisplay
of mode lines.
This command marks the current buffer as unmodified, and not needing
to be saved. If arg is non-
nil, it marks the buffer as
modified, so that it will be saved at the next suitable occasion.
Interactively, arg is the prefix argument.
Don’t use this function in programs, since it prints a message in the
echo area; use
set-buffer-modified-p (above) instead.
This function returns buffer’s modification-count. This is a
counter that increments every time the buffer is modified. If
nil (or omitted), the current buffer is used.
The counter can wrap around occasionally.
This function returns buffer’s character-change modification-count.
Changes to text properties leave this counter unchanged; however, each
time text is inserted or removed from the buffer, the counter is reset
to the value that would be returned by
By comparing the values returned by two
calls, you can tell whether a character change occurred in that buffer
in between the calls. If buffer is
nil (or omitted), the
current buffer is used.